Lsi 320 Bedienungsanleitung PDF herunterladen (Seite 28)

2-12 Detailed Host Adapter Installation

2.5 Setting SCSI IDs

SCSI IDs identify each SCSI device on the SCSI bus. Each SCSI ID on

a given bus must be unique. The IDs are 0 through 15 for a 16-bit bus.

The preset host adapter ID setting is 7 which gives the highest priority

to the host adapter.

If you plan to boot your computer from a SCSI hard disk drive, you must

assign SCSI ID 0 to the drive. Normally, you do not change the host

adapter SCSI ID setting from its default value.

Typically, you set the peripheral device SCSI IDs with jumpers or with a

switch on the peripheral. You must not duplicate SCSI IDs on a SCSI

bus. LSI Logic recommends that you record the SCSI IDs of all SCSI

devices. Table 2.1 provides a place to keep this record.

Table 2.1 SCSI ID Record for Dual Channel Adapter

SCSI ID SCSI Device Channel A SCSI Device Channel B

7 Ultra320 SCSI to PCI Host

Adapter

Ultra320 SCSI PCI to Host

Adapter

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 47 48

Keine Kommentare

Lsi 320 Bedienungsanleitung Seite 28