Lsi 40909G-S Bedienungsanleitung PDF herunterladen (Seite 21)

Installing the Sun SPARC Solaris Fusion-MPT™ Drivers 3-3

Step 2. When the banner is displayed, press the Stop-A keys to

interrupt the boot process and stop at the ok prompt.

Step 3. Use the show-devs command to list the system devices. You

should see an output similar to the following example, as shown

in Figure 3.1:

Figure 3.1 System Devices Listing

Note: /pci@1f,0/pci@1/pci@2/IntraServer,fc@4

identiﬁes the ﬁrst FC interface on an

LSI Logic/IntraServer 7000 Series adapter.

The above is an example. The output of show-devs may

vary depending on your system and conﬁguration. Use the

corresponding entries on your system, not those given

here.

If these devices are not listed, check that the adapter is correctly

installed, and reseat the adapter if necessary.

ok show-devs

/SUNW,UltraSPARC-IIi@0,0

/pci@1f,0

/virtual-memory

/memory@0,10000000

/aliases

/options

/openprom

/chosen

/packages

/pci@1f,0/pci@1

/pci@1f,0/pci@1,1

/pci@1f,0/pci@1/pci@2

/pci@1f,0/pci@1/IntraServer,Ultra2-scsi@1

/pci@1f,0/pci@1/pci@2/IntraServer,fc@4

/pci@1f,0/pci@1/pci@2/IntraServer,fc@4/disk

/pci@1f,0/pci@1/pci@2/IntraServer,fc@4/tape

/pci@1f,0/pci@1/IntraServer,Ultra2-scsi@1/tape

/pci@1f,0/pci@1/IntraServer,Ultra2-scsi@1/disk

/openprom/client-services

…

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 55 56

Keine Kommentare

Lsi 40909G-S Bedienungsanleitung Seite 21