LSI 9690SA-8E-KIT Installationsanleitung PDF herunterladen (Seite 122)

Chapter 2. CLI Syntax Reference

114 3ware SATA+SAS RAID Controller Card CLI Guide, Version 10.2

/cx/ex show pwrs

The /cx/ex show pwrs command applies only to 9750 and 9690SA

controllers. For the 9650SE, simply drop the prepended controller name in the

command and use /ex.

The /cx/ex show pwrs command shows a summary of power supplies with

their respective information for the specified enclosure.

The PowerSupply column lists the IDs of the power supply units, the Status

column lists the status of each power supply, the State column indicate if the

unit is ON or OFF, the Voltage and Current columns indicate whether the

voltage or current is under or over the required thresholds, and the Identify

column lists the Identify setting of the power supplies.

Example:

//localhost> /c0/e0 show pwrs

PowerSupply Status State Voltage Current Identify

--------------------------------------------------------------

pwrs0 OK on OK OK Off

pwrs1 OK on OK OK Off

/cx/ex show alarms

The /cx/ex show alarms command applies only to 9750 and 9690SA

controllers. For the 9650SE, simply drop the prepended controller name in the

command and use /ex.

Note that in this command, alarms can be abbreviated to alms. For example,

/cx/ex show alms.

The /cx/ex show alarms command shows a summary of the alarms within the

specified enclosure. The Alarm column lists the alarm units' IDs, the Status

column lists the status of each alarm, the State column indicates whether the

alarm unit is ON or OFF, and the Audibility column indicates whether the

alarm is Muted or Unmuted.

Example:

//localhost> /c0/e0 show alarms

Alarm Status State Audibility

---------------------------------------------------

alm0 OK OFF UNMUTE

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 137 138

Keine Kommentare

LSI 9690SA-8E-KIT Installationsanleitung Seite 122