LSI 9690SA-8E-KIT Installationsanleitung PDF herunterladen (Seite 128)

Chapter 2. CLI Syntax Reference

120 3ware SATA+SAS RAID Controller Card CLI Guide, Version 10.2

/cx/ex/almx show

The /cx/ex/almx show command applies only to 9750 and 9690SA

controllers. For the 9650SE, simply drop the prepended controller name in the

command and use /ex.

The /cx/ex/almx show command shows information about the specified

enclosure alarm. The possible status values are OK, FAIL, NOT-

INSTALLED, and ACTIVATED. The status values are described below. The

possible values for State are ON and OFF. The possible values for Audibility

are UNMUTE and MUTED.

Possible status values and their descriptions are as follows:

OK – Alarm device is functional and operational.

FAIL – Alarm device has malfunctioned and is not operational.

NOT-INSTALLED – Alarm device has not been installed.

ACTIVATED - Alarm device is functional, and an error condition has been

detected. This is a visual indication for the alarm, in addition to the sound. If

you mute the sound, the visual indication remains.

Example:

//localhost> /c0/e0/alm0 show

Alarm Status State Audibility

---------------------------------------------------

alm0 ACTIVATED ON UNMUTE

/cx/ex/almx set alarm=mute|unmute|off

The /cx/ex/almx set alarm command applies only to 9750 and 9690SA

controllers. For the 9650SE, simply drop the prepended controller name in the

command and use /ex.

The /cx/ex/almx set alarm command controls the audibility and state of the

enclosure alarm. It provides the ability to silence an activated alarm. It also

gives you the option to mute or unmute the alarm setting.

You can also use this command to prevent an audible alarm from sounding, in

the case where a known condition will set off the alarm, by muting the alarm

in advance.

If an error condition or degraded state is detected, the enclosure alarm or

buzzer sounds. To silence the alarm, you can either set the state of the alarm to

off, or you can mute the alarm.

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 137 138

Keine Kommentare

LSI 9690SA-8E-KIT Installationsanleitung Seite 128